Using a sponge, apply a thin layer of paste onto a clean, dry surface. Avoid snags. Estimate seam locations and apply a thin layer of paste to avoid snagging. You can also apply adhesive to paper-backed products. Once the wallpaper is dry, follow the steps above to hang it. Follow the correct procedure to know how to hang wallpaper with paste.
Tip: Apply an even layer of paste
Once you have selected your wallpaper, apply a thin layer of paste to the wall before hanging it. Once the wallpaper is evenly covered with the paste, you can now begin papering the wall. To hang wallpaper, start from the top of the wall and work your way down. Make sure you match the pattern and guideline of the wallpaper on the wall. You may need to overlap the edges of the wallpaper to prevent them from getting soaked by the first layer of paste.
Estimate seam locations
Start hanging the wallpaper in the least-viewed part of the room. Line up the first strip against the plumb line. Press the excess paper into the seam where the wall meets the ceiling. Press the pattern wallpaper into the seam as well. Smooth out the excess from the inside to prevent wrinkles and bubbles. Once the wallpaper is installed, follow these steps:
Avoid snags
Paper-backed wallpaper requires paste. Apply less paste to the edges, as they will form seams later. Use a thin paint brush to finish the edges of the wallpaper, rather than a large one, to avoid getting paste under or on top of the wallpaper. Start in a corner, close to the door, and unroll the paper to an overlap of about two inches at the ceiling and one-eighth inch in the corner. Gently push the new strip next to the seam of the previous strip.
Apply a thin layer of paste
The process of applying a thin layer of wallpaper paste to the walls is simple and straightforward. Follow the manufacturer’s instructions. Once the paste is applied, you can hang the wallpaper onto the wall. Once it is on the wall, you can use a seam roller to press the paper onto the wall. You should also wipe off any excess paste using a damp sponge. If the paste is still visible after hanging the last strip of wallpaper, the installation process isn’t complete yet.
Apply a thin layer of paste around corners
Before you begin hanging wallpaper, make sure that the wall is level. You can easily get off-level when hanging wallpaper around a window or door. If you don’t adhere your wallpaper to the wall correctly, the next wall will look wonky. Always measure your walls and leave 2 inches between corners so you can trim the edges straight. When hanging wallpaper, use a wallpaper adhesive to keep your edges from getting crooked.
Apply a thick layer of paste around doors and windows
This versatile product can be used on a wide variety of surfaces, including wood, tile, glass, concrete, aluminum, and metal. It can also be used on fabrics and other nonporous surfaces, such as PVC, EPDM, and CSPE. It can be applied to a variety of building materials, including brick, stucco, and masonry. Once dry, the paste can be easily trimmed to fit doorways and windows.